mikey94gt said:I would run the parts you posted there, and not worry about the sway bars. The car will handle pretty good without going too serious with those. instead, put some rear lower control arms in, and definitely do subframe connectors.
Also, if you dont wanna worry about drilling the hole for the 4th bolt in the right place, Griggs has a set of CC plates that use 3 bolts, and are just as strong as every one elses that use 4.
mikey94gt said:Also, if you dont wanna worry about drilling the hole for the 4th bolt in the right place, Griggs has a set of CC plates that use 3 bolts, and are just as strong as every one elses that use 4.
OnyxCobra said:mikey94gt said:Also, if you dont wanna worry about drilling the hole for the 4th bolt in the right place, Griggs has a set of CC plates that use 3 bolts, and are just as strong as every one elses that use 4.
I'm seeing $330 for the Griggs?! Mingya man.
I was going to say look into the MM plates instead of Steeda too, but I'm not even sure it makes a difference. I think it's more get what you like the look of.
MustangChris said:i got BBK Gripps for my car...... ... . . they are defianantly going to be temporary... LOL
mikey94gt said:MustangChris said:i got BBK Gripps for my car...... ... . . they are defianantly going to be temporary... LOL
Yeah, not impressed with anything BBK. I am slowly replacing BBK stuff on my car with Trick Flow or Pypes, depending on what the item is. Accufab may get the nod for the new Throttle body though.
MustangChris said:mikey94gt said:MustangChris said:i got BBK Gripps for my car...... ... . . they are defianantly going to be temporary... LOL
Do you have a link? Im curious. send it pm so we dont clutter this poor guys thread, lol!!
Yeah, not impressed with anything BBK. I am slowly replacing BBK stuff on my car with Trick Flow or Pypes, depending on what the item is. Accufab may get the nod for the new Throttle body though.
i personally like the deamon 75mm tb+plenum set up... very clean!