become a supporting member

  • Recent Forum Posts

    ttocs

    the momstang rebuild begins

    still not totally sure it will work myself. I made a foam seal that went between the plexi and the body panel so that it will not leak and when I pushed

    ttocs Today, 05:31 PM Go to last post
    Venomuz98

    New to the site

    welcome to the site

    Venomuz98 Today, 05:30 PM Go to last post
    ttocs

    Like or Hate? Video Clip

    I had to laugh that they are looking at a new edge mustang and dreaming of something with curves..... Wonder where they could find a similar mustang

    ttocs Today, 05:27 PM Go to last post
    ttocs

    Trunk Drain Channel

    if your going to go as far as to spray I would take some time to drag some 220-320 grit sand paper over it to smooth it out.

    ttocs Today, 05:25 PM Go to last post
    BMAC96GT

    Complete rebuild on T45...same problems. Opinions??

    Just throwing this out there for the more knowledgable than me, but can a bad pilot bearing or clutch affect shifting? I know the pilot bearing has a

    BMAC96GT Today, 05:24 PM Go to last post
    sn95jones

    The New Kid

    That would be the place for the rear defroster button if the car came with it, looks like it didn't, someone has/had an after market alarm installed on

    sn95jones Today, 05:23 PM Go to last post
  • Facebook Activity