Reply to thread

Message: <blockquote data-quote="ttocs" data-source="post: 1574322" data-attributes="member: 11896"><p>ok, gotcha.  The RCA outputs are a low voltage level output from the deck used to connect to amps that then amplify the signal.  It then takes that signal and runs it through a simple amp to make the speaker outputs that go to the speakers.  Generally you use one or the other depending on if you have amps(like the mach system does) but that is not to say that you could not hook up the mach amps, then power additional speakers from the deck but it isn't really recommended as the deck speakers will tend to start distorting before a set with a good amp behind them.  In your case I would be careful to insulate the speaker wires not used(any wire not used) because if they short out it can turn the deck/amp off.</p></blockquote><p></p>