/ Register

Aluminum Driveshaft

Discussion in '96-04 - 2V Specific' started by 97stanger, Jun 13, 2007.

  1. Jun 13, 2007 #1
    97stanger

    97stanger Legend

    Messages:
    5,880
    Likes Received:
    95
    Joined:
    Mar 22, 2006
    When i eventually build up my rear with moser 31 spline axles and an eaton posi rear diff, i wanted to also throw in an aluminum drive shaft. Problem is, everywhere i find them they "only fit 5 speed manuals". Does anybody know where to find driveshafts that fit 97 GT autos??? thanks guys
     
  2. Jun 13, 2007 #2
    Downshift

    Downshift Well-Known Member

    Messages:
    1,957
    Likes Received:
    0
    Joined:
    Jan 21, 2006
    Dont you just change the end that goes into the tranny with your old one?
     
  3. Jun 13, 2007 #3
    DropTopPony

    DropTopPony Administrator Staff Member Admin SN95 Supporter

    Messages:
    15,342
    Likes Received:
    119
    Joined:
    Jan 12, 2006
    Location:
    South Jersey
    You buy the 5 sp unit then put your auto yokes on and install.
     
  4. Jun 13, 2007 #4
    97stanger

    97stanger Legend

    Messages:
    5,880
    Likes Received:
    95
    Joined:
    Mar 22, 2006
    is it worth doing this while redoing the rear or should i not even bother?
     
  5. Jun 13, 2007 #5
    DropTopPony

    DropTopPony Administrator Staff Member Admin SN95 Supporter

    Messages:
    15,342
    Likes Received:
    119
    Joined:
    Jan 12, 2006
    Location:
    South Jersey
    go for it, its a better quality part then stock and reduces rotating mass...get a driveshaft safety loop installed while you are having the shaft out.