OP
OP
Mine is 0000 (4/0) awg. I know its kind of overkill, but it was free.
Battery relocation wire routing
- Thread starter lwarrior1016
- Start date
I ran mine through the grommet on drivers side wiring harness. From there goes bottom of kick panel, keeps going to the side of the sill panel straight to the trunk. At the trunk goes towards the passenger side. I have a fuse in the front and a circuit breaker in the rear. If you get a circuit breaker get BlueSeas brand or a known brand and not a cheap $10 one. As I found out don't turn on fans while cranking as it will blow fuses. Mine did with 150a fuse important to set up MS to not power on fans at cranking rpm.
I do like the channel idea. Didn't realize that was there.
Is it accessible without pulling the fender?!??
This message courtesy of crapatalk!
Is it accessible without pulling the fender?!??
This message courtesy of crapatalk!
OP
OP
I think it's accessible after you pull the inner fender liner but I'm sure it would be a real pain to do with the fender in the way.
Dagnabit..............
I guess I'll just pull the fender when I'm ready!!!! Lol
This message courtesy of crapatalk!
