Coyote SN95

[neverenuff]

The best way to fit these engines is from the bottom up, plenty of clearance for the wide heads.

 

[neverenuff]

It is a tight fit, the steering shaft is still too close to the drivers side header, the oil pan still needs to be modified/purchase the swap one, but it is IN the car now.

 

[neverenuff]

This is Scram Speeds pedal bracket installed, the pedal that comes with the kit has three ears on it, the upper right hand one needs to be trimmed in order to fit against the firewall.

 

[bluex]

Am I the only one who cant see the newest pictures? Tried a few different computers too.

 

[Burninriverdiver]

Am I the only one who cant see the newest pictures? Tried a few different computers too.

I can't see them either, the first page works but the new ones don't.... Keep posting! I'm looking forward to seeing more

 

[bluex]

I can't see them either, the first page works but the new ones don't.... Keep posting! I'm looking forward to seeing more

Ya I see the first ones to am not the newest ones.

 

[neverenuff]

Hopefully you can see the pictures now, I think it was a compatibility setting issue, I finally got under my car this weekend and took some more pics ..

 

[neverenuff]

I wrapped what I could get to with the headers, it gets HOT especially these California summers.

 

[neverenuff]

I ran the O2 sensor harness and the positive cable for the starter through the middle of the header, again no clearance! P.S. don't mind my corroded oil pan bolts.

 

[neverenuff]

The BBK long tubes and 3'' x-pipe sure let this engine breathe, I still need to find a 3" cat-back.

 

[neverenuff]

Here is the passenger side of the motor, the Power By the Hour brackets allow the use of stock power steering hoses. Oil Cooler: still need to delete it or go aftermarket, does anyone know what I need to delete this? Will the Mustang one work?

 

[neverenuff]

Oil pressure sender, I couldn't get the stock guage to work nor did I want to depend on it so I picked up an electronic Autometer one.

 

[neverenuff]

Clearance between the oil pan and k-member before I set the engine 1" back in the engine bay.

 

[stingracer]

Dang. None of the pics are working. The previous ones used to.

Sent from my SM-T230NU using Tapatalk

 

[DKblue98GT]

This build sounds killer but I can't see any pictures....

 

[evilcw311]

Tapatalk is the easiest way to post pics with no issues. Send pics straight from your phone.


This message courtesy of crapatalk!

 

[Mus-Tango]

i think this one's a nice build too but I can't view the photos

 

[neverenuff]

It took awhile because I stripped the carrier bolt and had to cut it out but 3.73's are installed

Sent from my SM-N900V using Tapatalk

 

[neverenuff]

Fighting the sun but here is a picture with it installed and the air box that comes with the FRPP control pack, the one piece that had me scratching my head....

Sent from my SM-N900V using Tapatalk

 

[neverenuff]

Only a few modifications, haha if you use an aftermarket one, you have a lot of space to work with

Sent from my SM-N900V using Tapatalk