hiperformancesolutions.com

kid rock

New Member
Joined
Sep 5, 2006
Messages
34
Reaction score
0
http://www.hiperformancesolutions.com

has anybody used the adaptor plate from the above website when doing the PI intake conversion??

as i read somewhere you might have to slice a bit of the manifold off to make it fit??

this true or am i being very silly again :hammer:

Si
 

whty98

Active Member
Joined
Sep 26, 2006
Messages
263
Reaction score
0
I've never heard of this company but I'm sure that they would work fine. I'd use these if I had nitrous or FI but just a regular motor just use the PI and non-PI intake gaskets

I've never seen that intake, I wonder if it's worth buying?
 

Gtnut1996

Member
Joined
Nov 11, 2006
Messages
227
Reaction score
0
i know another company made adapter plates for a pi. The intake did have to be cut down. I believe it was detriotspeedworks.com. It was discontinued not long after it came out though. I believe it was 800 bucks with a new cut pi intake. I am just putting a pi on my non pi heads without the plates. When the manifold I want comes out it will be getting changed then.
 

DropTopPony

Post Whore
SN95 Supporter
Joined
Jan 12, 2006
Messages
15,376
Reaction score
203
Location
South Jersey
Gtnut1996 said:
i know another company made adapter plates for a pi. The intake did have to be cut down. I believe it was detriotspeedworks.com. It was discontinued not long after it came out though. I believe it was 800 bucks with a new cut pi intake. I am just putting a pi on my non pi heads without the plates. When the manifold I want comes out it will be getting changed then.
Detroit SW merged with Livernois Motorsports and the intake kit is now @$500
 

DropTopPony

Post Whore
SN95 Supporter
Joined
Jan 12, 2006
Messages
15,376
Reaction score
203
Location
South Jersey
kid rock said:
http://www.hiperformancesolutions.com

has anybody used the adaptor plate from the above website when doing the PI intake conversion??

as i read somewhere you might have to slice a bit of the manifold off to make it fit??

this true or am i being very silly again :hammer:

Si

HPS is a good company and the intake is sweet...i have called them about these plates and they were supposed to call me back when they were ready. Give them a call or shoot them an email and maybe they will get them ready. I have a project i'd like to use those plates on.
 

voidfinger

Well-Known Member
Joined
Dec 16, 2006
Messages
3,880
Reaction score
0
thats a really nice intake but i think i like the trick flow intake better and i think its going to be the same $$$$ to, wow i thought it said that it used cast teck and it was supose to be cheaper!!!!
 

Latest posts

Forum statistics

Threads
77,438
Messages
1,502,153
Members
14,919
Latest member
Alida81

Members online

Top