How not to install MC

Discussion in 'Tech Articles, How-To's & Write Ups' started by Matt94GT, Jan 13, 2006.

  1. Matt94GT

    Matt94GT Legend SN95 Supporter Retired Staff

    Messages:
    11,861
    Likes Received:
    56
    Joined:
    Jan 10, 2006
    Location:
    Victoria, British Columbia, Canada
    How not to install a MC bolt it to the plunger then try to bend new lines and thread them in.  I stripped mine...dammit!!  I was just too excited to get it all done.   :hammer:

    Hook up the lines first then hook up the other end of the lines with it free, THEN bolt it up, and take ur time bending the lines and re-attaching dont bend them while attached lol.
     
  2. HISSIN50

    HISSIN50 New Member

    Messages:
    89
    Likes Received:
    0
    Joined:
    Jan 11, 2006
    Hmmm, sounds like something I would do. LOL.

    A very good tip and reminder! (I seriously think this little area will help people not make mistakes).

    Great tip!
     
  3. Tattoogod

    Tattoogod Active Member

    Messages:
    278
    Likes Received:
    0
    Joined:
    May 8, 2006
    this may sound stupid..but what is a MC im drawing a blank here ;D
     
  4. rgs

    rgs Well-Known Member

    Messages:
    1,368
    Likes Received:
    0
    Joined:
    Jan 11, 2006
    master cylinder :p
     
  5. Tattoogod

    Tattoogod Active Member

    Messages:
    278
    Likes Received:
    0
    Joined:
    May 8, 2006
    :rollinglaugh: man its been a long day i was thinking to hard again.im still trying to clear the memory of my computer