Ineedav8
Active Member
I'm stuck in the middle as I know my throwout bearing is squeaking in my tr3650 I want to replace it but I'm not going to pull the trans to replace a small bearing lol so I have a list of parts I'm tossing around the idea on as it will be a daily driver current mods are ported pi heads stage 2 CMS cams beehive valve springs mach 1 trans full exhaust pi intake accufab elbow 75mm tb and so on so forth i plan on tossing a teksid block with navi heads on boost down the line just looking for a combo to hold the magic here's the list so far
1. SPEC Stage 1/2 clutch with a timken throwout bearing
2. Billet aluminum flywheel with replaceable friction disc's
3. Misc. Gaskets for the tr3650
4. Would I need to worry about syncro's being she has been grinded a few times ??
And for the rear end I had the intention of
1. Moser 31 spline axles
2. Welded housing
3. Aluminum drive shaft
1. SPEC Stage 1/2 clutch with a timken throwout bearing
2. Billet aluminum flywheel with replaceable friction disc's
3. Misc. Gaskets for the tr3650
4. Would I need to worry about syncro's being she has been grinded a few times ??
And for the rear end I had the intention of
1. Moser 31 spline axles
2. Welded housing
3. Aluminum drive shaft