Last year, I broke the key off in the ignition. Yes, I said last year. Today, I pulled the old one out and put the new one in but somehow goofed. Now I can't put the cylinder back into the...carrier? It appears to me I added an unecessary step. Here's what I did, tell me where I went wrong:
1) disconnected battery
2) turned key to "on/run" position
3) pushed in pin
4) removed old cylinder and column upper plastic
5) replaced plastic
6) tried to install new cylinder but pin wasn't pushed in..
7) removed cylinder from carrier, pushed in pin, slid into column and pushed pin in.
8) tried to insert cylinder into carrier but it doesn't seem to wanna jive..
9) @$%£ this sh*t, I'm going inside to watch Game of Thrones!
Seems like I wasn't supposed to remove the cylinder from the carrier?? Didn't look like it would slide into the column without the pin pushed in? Where'd I go wrong?
1) disconnected battery
2) turned key to "on/run" position
3) pushed in pin
4) removed old cylinder and column upper plastic
5) replaced plastic
6) tried to install new cylinder but pin wasn't pushed in..
7) removed cylinder from carrier, pushed in pin, slid into column and pushed pin in.
8) tried to insert cylinder into carrier but it doesn't seem to wanna jive..
9) @$%£ this sh*t, I'm going inside to watch Game of Thrones!
Seems like I wasn't supposed to remove the cylinder from the carrier?? Didn't look like it would slide into the column without the pin pushed in? Where'd I go wrong?