Moving stock k member

[ttocs]

M&M has instructions on how to measure to square it up towards the end of their K-member install.

https://www.maximummotorsports.com/assets/install/pdf/front_susp/MMKM-1r5.pdf

 

[Notthenow]

Thanks toccs, I read over it once quickly before and assumed that it only applied to their part, but now I think I can apply the front location and use the rearward lca bolt hole if I understand it correctly.

 

[ttocs]

it would work for any k member I am pretty sure. Its not too hard to measure it up as long as you have a buddy to help hold the tape measure.

 

[Werecow]

Here's another help in how to square one up as well, Eric uses the MM guide as well..

 

[Notthenow]

Thanks Evil, I did watch that. Very well done. It did confuse me at the end when he explained what it means if the diagonals don't match. Either he said it backwards or I heard it backwards...
Either way I will re-measure with fresh checking points, see how out of wack it is and go from there.