My Cam update!!

Rantheman

Well-Known Member
Joined
Aug 12, 2006
Messages
1,050
Reaction score
0
Well I am getting to the point were I am ready to degree my cams I just havn't figured out which route I am going to take if I am off from the specs. one is I will grind the keyway off or 2 I will use the chain to bring it back not sure yet. but this Project has waited to long I need to get done I have been really busy as you can see i have some surface rust on my cams now but I oil them every other day. so bare with my and I will let you know how it goes.

The Motor
2632.jpg

My plate For the dial indicator for the valve spring
mustang271.jpg

Also made a plate for the dial indicator to sit for TDC(top dead center)
mustang272.jpg

The motor again
mustang273.jpg

The degree wheel the water pump is coming off tonight
mustang274.jpg
 
OP
OP
R

Rantheman

Well-Known Member
Joined
Aug 12, 2006
Messages
1,050
Reaction score
0
opps i didn't mean to post this in the 5.0 section sorry :santa_embarassed:
 

Dalamar

Post Whore
SN95 Supporter
Joined
Feb 3, 2006
Messages
13,863
Reaction score
124
Location
SLC, UT
Good luck man, that should be nice.

Are you going to dyno it afterwords or someting like that?
 
OP
OP
R

Rantheman

Well-Known Member
Joined
Aug 12, 2006
Messages
1,050
Reaction score
0
Matt-Thank you very much :santa_cool:

Droptop I did get your e-mail thank you

Dalmar- I am getting on the dyno after this about january
 

Latest posts

Forum statistics

Threads
77,438
Messages
1,502,151
Members
14,919
Latest member
Alida81

Members online

Top