Need help removing steering wheel

NicksGTR

New Member
Joined
Apr 27, 2007
Messages
59
Reaction score
35
So I wanted to remove my steering wheel on my 01 Bullitt. Got the wheel puller out, tightened the bolts into the pot metal and slowly turned the the center bolt to apply pressure on the torx bolt. Pop! One of the tightening bolts pulled out, stripped the threads. I have tried putting my knees behind wheel, hand on top and hitting the torx bolt with my brass hammer while pulling, this thing is stuck. PB Blaster also applied. I have ordered a drill and tap to try the puller again. Fingers crossed. This car has 30k original miles, go figure.
 

ttocs

Post Whore
Joined
Oct 9, 2009
Messages
32,394
Reaction score
5,561
Location
Evansville Indiana
I have had luck getting mine off by just thumping the top of the wheel, then the bottom, then each side and then giving a slight pull.
 

cobrajeff96

Well-Known Member
Joined
Feb 1, 2022
Messages
1,607
Reaction score
1,483
Location
Germany
Two-jaw puller worked for me when I did the same thing one time, stripping one or more of the hub threads on the wheel.
 

weendoggy

Active Member
Joined
May 31, 2019
Messages
619
Reaction score
702




i use a set like this and have it tight if it dose not break lose hit the center bolt with a hammer to shock it breaking lose
some time you must use force
Yep, use something similar and beat the living hell out of it...works every time. Of course, it knows you're going to beat the crap out of it so it breaks loose instead. o_O
 

RAU03MACH

Legend
Joined
Apr 23, 2019
Messages
6,718
Reaction score
6,513
Location
NEW MEXICO
i had one seized on me i had to use a torch to heat it up and thats bad you take a chance on melting and burning contacts and plastic
 

lwarrior1016

Mr. Secondary Timing Chain
Staff
Joined
Sep 22, 2014
Messages
8,484
Reaction score
4,236
Location
South Mississippi
So I wanted to remove my steering wheel on my 01 Bullitt. Got the wheel puller out, tightened the bolts into the pot metal and slowly turned the the center bolt to apply pressure on the torx bolt. Pop! One of the tightening bolts pulled out, stripped the threads. I have tried putting my knees behind wheel, hand on top and hitting the torx bolt with my brass hammer while pulling, this thing is stuck. PB Blaster also applied. I have ordered a drill and tap to try the puller again. Fingers crossed. This car has 30k original miles, go figure.
Did you take the t50 torx out of the center first?
 

Latest posts

Forum statistics

Threads
77,440
Messages
1,502,175
Members
14,920
Latest member
marktuck99

Members online

Top