Fillywardo
New Member
- Joined
- Apr 28, 2020
- Messages
- 1
- Reaction score
- 0
Hello everyone!! This is my first post on the forum. I’m swapping a 4.6 from a 96 GT (entire donor car) into my 2003 Mustang. I have the engine inside, the ECU wiring harness is ran, ECU inside and plugged in,
I went to plug in the 3 smaller connections at the ECU and noticed the plugs were all Female on my 03 interior Side and the 96 GT ECU wiring side and if I’m not mistaken the dash harness meets the ECU there.
which brings me to the question... I can swap over the dash harness from my ‘96 and plug in the ECU no problem. But then I can’t use my 99/01 cobra gauge cluster because the dash harness uses different connectors on SN95.
Is there any way possible I could splice the connectors? Maybe an earlier new edge harness like 99 will plug into my 96 ECU harness and allow me to use the gauges? I’m not worried about PATS I have a handheld tuner. Thanks so much guys.
I went to plug in the 3 smaller connections at the ECU and noticed the plugs were all Female on my 03 interior Side and the 96 GT ECU wiring side and if I’m not mistaken the dash harness meets the ECU there.
which brings me to the question... I can swap over the dash harness from my ‘96 and plug in the ECU no problem. But then I can’t use my 99/01 cobra gauge cluster because the dash harness uses different connectors on SN95.
Is there any way possible I could splice the connectors? Maybe an earlier new edge harness like 99 will plug into my 96 ECU harness and allow me to use the gauges? I’m not worried about PATS I have a handheld tuner. Thanks so much guys.
