Performance Shop near Roseville, CA

[five0racer]

Hi to all the sn95 5.0 guys. We are a rare breed.

I am hoping someone knows a shop that can work on custom 5.0 in the Roseville or Sacramento area. 95 Cobra with S-trim, and the motor is frankensteined out with pre 93 mods. I need the shop to diagnose lifter issue(s) , unburnt fuel, compression test, and rear diff pre-load. ECU running Tweecer custom tune.

Thanks in advance!



Vortech V2 S-Trim, Performer RPM heads and manifold, TF 75mm TB, 42# injectors, BBK fuel rails, Aeromotive FPR, main girdle, 2003 IRS, MM K & bilsteins, Tweecer RT, 1-5/8 short tubes, Bassani off-road X, stock 2003 cobra exhaust.

 

[RAU03MACH]

for the lifters can you remove your valve covers just to make sure the oil is getting to the top of rockers you wont start the motor just bump it over by hand
also look at rockers make sure they are up and down motion not bunding
im just trying to help you eliminate a shop for the time being by trouble shooting
a compression tester is very easy to use just need to ask

 

[five0racer]

for the lifters can you remove your valve covers just to make sure the oil is getting to the top of rockers you wont start the motor just bump it over by hand
also look at rockers make sure they are up and down motion not bunding
im just trying to help you eliminate a shop for the time being by trouble shooting
a compression tester is very easy to use just need to ask

Thank you. I think the same lifter/rocker has already broken a push rod tip in the past. I replaced the push rod and it might have done it again. I have compression tester, just being lazy and wanted a professional to look at it.

 

[CobraRGuy]

Elliot Franklin Mustang Corral 22605 Swenson Ravine, Grass Valley, Ca 95949
Sorry I don't have a phone number for him but he is highly experienced and does high quality work.

 

[CobraRGuy]

Elliot Franklin Mustang Corral 22605 Swenson Ravine, Grass Valley, Ca 95949
Sorry I don't have a phone number for him but he is highly experienced and does high quality work

Try 530-268-8403