Replacement of the brake hard lines?

[Jedimeister]

Hi... new guy here. Just got a 98 GT and of course as soon as I get her, the steel brake line going from the front to the back of the car springs a leak. So, I need to replace the steel brake line that goes from the master cylinder to the rear of the car. Anyone have experience replacing that? Are there any tricks to fishing it through? I got a pre-bent kit off of CJ Pony Parts.

 

[Jedimeister]

Well... in case anyone is looking for this info, I got this done. Luckily I have a friend with a 2 post lift. If it hadn't been for that, I don't know how I would have got it done in the garage on jack stands. The pre-bent lines I bought we pliable so it was not too difficult to bend it around the things I needed to. Getting the ends to mate up properly took a bit of patience, so take your time.

Again, I don't think I would try doing this without a lift.