snapped bearing retainer

Discussion in 'Drivetrain' started by SIarcher, May 8, 2015.

  1. SIarcher

    SIarcher New Member

    Messages:
    1
    Likes Received:
    0
    Joined:
    Apr 17, 2015
    Location:
    Southern Illinois
    Pulled the transmission yesterday because my TOB has been chattering. The bearing was sized to the retainer and it was obviously snapped off. What should I replace it with? I found a billet one on the t45 source.
    My clutch fork also has a little wear on it where the whole bearing was spining on it. Should I replace it and if so what should I get?

    I am also replacing the clutch, pilot bearing, resurfacing flywheel, rear seal, throwout bearing, clutch cable and quadrant.

    Thanks