MoonlightGT said:
great pics thanks. hey, how did you install the overlay without removing any needles??
Through the shear awesomeness that is me.
But seriously, it was a super pain in hole - but I didn't want to have to worry about resetting the needles properly.
The overlay that I got from that guy came in 3 pieces as can be seen in the pic below:
Both the overlays and the needles are kinda bendy, so I slid each piece slowly over the needles and wiggled them into place. For example, the two outside overlays would be slid from the top left towards the bottom right and the middle overlay from the bottom left towards the top right. Each case you slide against the grain of the needle, so once you clear the needle, you just have to wiggle the overlay in place over the humpy things.
Not sure how helpful that is, but I'd be happy to answer any questions you have. 8)