Wichers123 thrift shop build!

[Wichers123]

Been busy with work and I've slowly been working away things to get this engine together. Well the cams I didn't really know what I got into but dove right in and found out ptv clearance was a joke lol. So I had to fly cut the pistons, so I been reading on the diy cutters and well I jumped on that. I also purchased a new set of valve from cushman that are machined to give even more ptv clearance.

Here it was setup to check ptv clearance.

 

[Wichers123]

This is one bank fly cut and bottom end painted.

 

[Wichers123]

The intake and exhaust port worked. And assembling the head.

 

[Wichers123]

One head setup fully assembled and timing set to check ptv clearance. Plenty of clearance btw.

 

[96blak54]

You wouldnt happen to have any picks of the port floor/short side radius area directly behind the valve?

 

[MustangChris]

One head setup fully assembled and timing set to check ptv clearance. Plenty of clearance btw.

did you degree the cams? just curious.

 

[Wichers123]

You wouldnt happen to have any picks of the port floor/short side radius area directly behind the valve?

I didn't mess with that to much I just opened up behind the valve seat and worked the seat base lip to a ramp instead of being a wall.

did you degree the cams? just curious.

No not yet it's a cloyes hex a just so when it's time to put together for good ill degree them.