Rallim
Active Member
Quick question for you guys. Long story short, I've got an opportunity to pick up an H-Beam terminator bottom end and supercharger setup, and then I figure I can find a Mark VIII motor to put it all in for a few hundred bucks.
Now, I know the K-member would have to be swapped, obviously who harness/ecu as well. Would I run into any troubles putting the M112 on a Mark VIII, any little things I'd need to know to expect, and last would it even be worth it?
I figure short of any unexpected odds and ends I could essentially have a forged bottom end terminator swap for under $2000, but I'm not 100% so I figure I'd rather get opinions before even starting to really think about it.
Now, I know the K-member would have to be swapped, obviously who harness/ecu as well. Would I run into any troubles putting the M112 on a Mark VIII, any little things I'd need to know to expect, and last would it even be worth it?
I figure short of any unexpected odds and ends I could essentially have a forged bottom end terminator swap for under $2000, but I'm not 100% so I figure I'd rather get opinions before even starting to really think about it.