Reply to thread

Message: <blockquote data-quote="ttocs" data-source="post: 1447254" data-attributes="member: 11896"><p>you really should only need to identify 2 wires, the turn signal and the ground, but there are 2 other wires as well that I mentioned above.  The parking lights are commonly a brown wire to take one out of the mix that you do not need.  Get a meter/test light and turn your turn signal on and start checking the wires going to the bulbs until you find one pulsing 12v-0v as the bulb turns on/off.  Cut the wire going to the bulb(leave a few inches in case you need/decide to reconnect it) tap the ground right next to it and run that down to the new turn signal bulb in the new spot</p></blockquote><p></p>