Reply to thread

Message: <blockquote data-quote="Deceptive GT" data-source="post: 1497658" data-attributes="member: 20380">Yes, so I was leaning a few different ways. I was interested in Tuxedo Black but also in maybe a red but not Torch Red like the car is currently. I was liking the Rapid Red Metallic but I was vetoed, my wife wanted something in a dark blue. We were looking at the Midnight Blue Metallic until I saw a picture of the Antimatter Blue Metallic. That is the winner.I did get the Carbon Driven Radio bezel in and the 4.15" Pulley. I also ended up ordering a new Shifter Bezel Trim Ring and a trunk nets for both he GT and the Mach 1. Tomorrow the BOV should be here. I ended up ordering the Procharger Big Black Race Valve.The current plan is to clean up the garage and get the Mach 1 pulled in along side the GT. I want to drop the front suspension and replace the oil pan, steering rack, replace all the steering lines with AN stuff, and replace the front suspension components. I decided to order the MM K for the GT since nobody can confirm that any of the Coyote Swap with 6R80 headers fit the Steeda K. The Steeda K will be going on the Mach 1. I am going to order the 14point7 ADV Wideband specifically to integrate into the MS3PNP through Canbus and use the Innovate stuff for my visuals. I have the PSB-1 and ECF-1 so I set visual warnings since the MS3PNP doesn't have CEL capability. I am sending my lower intake off to have a PSR done, I am going with 10" runners.The big thing right now is to get the garage cleaned so I can get the Mach 1 in and get some good weather. Weekends have been cold and wet lately.</blockquote>