Reply to thread

Message: <blockquote data-quote="Grinch347" data-source="post: 1501630" data-attributes="member: 23596"><p>With the AeroCatch pins, there is a small rubber washer that you trim down to support the hood. I used my stock hood bumper spots to mount the pins. After doing what those have mentions above (using a dab of grease on the top of the pin) I only made the hole on the underside of the hood big enough to clear the rubber washer. You can see the hole I have in mine.</p></blockquote><p></p>

Verification

Random media

2017 setup

My Mustang P2

Latest posts

What Did You Do To Your Car Today?
- Latest: NEW EDG
- Today at 8:48 PM
The Garage
cup/drink holder upgrade ideas?..
- Latest: Slice
- Today at 8:34 PM
Exterior and Interior
A
1995 crank but no start situation
- Latest: Armand
- Today at 8:32 PM
94-95 5.0 - Specific
V6/GT rear spoiler 94/95?
- Latest: Slice
- Today at 8:30 PM
Exterior and Interior
Leaky oil temp sending unit
- Latest: Daryl
- Today at 7:12 PM
94-95 5.0 - Specific

Share this page

Reddit Pinterest Tumblr WhatsApp Email Link

Forum statistics

Threads: 78,555

Messages: 1,536,137

Members: 16,201

Latest member: jgib8795

Members online

PinkieT

Total: 659 (members: 1, guests: 658)

Top