Reply to thread

Message: <blockquote data-quote="Duckboy4" data-source="post: 1585716" data-attributes="member: 37961">Super old thread, but I found it because I twisted off a bolt taking the driver's seat out and needed to know what size.  The two rear bolts take an M10 x 1.5 bolt with a 15mm head and a captive washer.Pro tip:  If you don't have an M10 x 1.5 tap to clean up the threads on the floor pan, you can use a 3/8 NC 16 tap.  It's a little bit smaller but will get the hole cleaned out and prepped for the proper metric bolt.  I wound up buying a rando from Ace Hardware because my local Ford dealer didn't have any in stock (and were going to make me buy 5).Cheers!</blockquote>