Reply to thread

Message: <blockquote data-quote="garrittpwl" data-source="post: 1542027" data-attributes="member: 21560">Update* I think I've got a decent starting point. Gonna check the "mid range" brake pressures when I get someone to sit and hold the pedal at different levels.With the factory non.abs valve in place and a wilwood valve on the rear line set to minimum, my pressures full lock up ar 1250ish front and 400ish rear. 1650psi total for a front/rear bias of 75.7/24.3. Since the caliper size, pad and rotor size are all the same, this is my only variable. I'm gonna dial it in a little so it gets closer to 70/30 and then check pressures in the lower ranges too but I think I've accomplished what I was aiming for.Video here showing the readings[MEDIA=imgur]a/YGzJhMG[/MEDIA]</blockquote>