Reply to thread

Message: <blockquote data-quote="Blueoval" data-source="post: 6735" data-attributes="member: 8298">Guys my car has a 148K miles on the motor right now and it starting to use quite a bit of oil so I am getting ready to build a good budget non-PI motor for my car that will make good power as far as a NA setup as well as running a 75-100 Dry shot from time to time.Here is the build up specs:'96 GT Block (low mileage) - getting a great deal on'96 GT Crank (low mileage) - getting a great deal on'95 Mark VIII Pistons (low mileage) - getting a great deal on'95 Mark VIII Rods (low mileage) - getting a great deal onClevite Main & Rod Bearings'98 NPI Heads that are going to be P&P'd and a valve job done on - just costing me the headworkSVO Intake (already ported with everything that I need) - $400 because of helping a friend do all of the work on his carSHM 2730 Cams (already running in my current motor) - only spent $300 on these about 2 years agoEither do some work on the T/B that comes with the intake or get the Accufab unitFRPP 30 lb injectors - free from the friend that I am getting my SVO intake fromPro M Meter already calibrated for the 30 lb injectors - free from the friend I am getting the SVO intake fromFRPP Shorties (already on the car)Bassani High Flow X (getting ready to go on the car)SCT 4-position chip (still need to get one so that I can have a tune for 75 and 100 as well as my NA tune)Steeda Pullies (already on the car)Screamin Demon coil packs (already on the car)Screamin Demon Livewires (already on the car)'01 GT Water PumpKirban Adjustable Fuel Pressure Regulator (already on the car)Windage Tray - (still need to get)Oil Filter Relocation Kit - (still need to get)Oil Cooler - Getting a deal onOther stuff that I have still to install:NOS Dry kit - (getting a deal on) but I still need to get all of the safety featuresUPR Chromoly K-member - Free from the same friend that I am getting the intake fromD&D Coilover kit with 350 lb springs for the front - My friend bought them for me for ChristmasMM 4-point CC Plates - My friend bought them for me for my BirthdayTokico 5-way adjustable Illumina Shocks & Struts - (already on the car)D&D Coilover kit for the rear - (still need to get)MM full length subframes - (already have on the car)HPM Megabite Jr. lowers - (already have on the car)HPM Severe duty panhard bar - (already have on the car)Steeda Tubular front swaybar - (already have on the car)MM 4-point Gload brace - (already have on the car)Kenny Brown Super Street Cage - (still need to get)EVM Center X with built in DS loop - (still need to get)EVM Radiator Enclosure V Brace - (still need to get)EVM Tri-link Kit - (still need to get)With this motor setup I will have 10.46:1 compression with non-PI heads. I am hoping to see over 300 rwhp with this motor setup and then over 400 rwhp on the 100 shot. I am not looking for tons of power because I have my car setup for a fun handling car / street car.Let me know your thoughts.Lee</blockquote>