Reply to thread

Message: <blockquote data-quote="Mustang5L5" data-source="post: 1582429" data-attributes="member: 30520">Are you installing it in a plastic air tube?When i swapped my Fox over to an aftermarket ECU, i ran into issues leaving the IAT in the intake manifold, so I wanted to move it to the plastic intake tube.  Same issue with installing a threaded sensor into a plastic tube.  I;m sure it would have threaded in, but I wanted something a little cleaner. SO i purchased an IAT sensor for a 96-00 4.6L Mustang.  Same resistance temp values as the sensor on the 5.0, but designed to insert into a grommet.  I drilled the tube, purchased a tight rubber grommet and it installed nicely. EDIT:  I'm using a Motorcraft DY-735.  Bought a wiring harness plug for it off amazon.  Can dig that up if needed. [ATTACH=full]47862[/ATTACH]</blockquote>