Reply to thread

Message: <blockquote data-quote="ttocs" data-source="post: 1507596" data-attributes="member: 11896">trace/follow the green wire from the servo back towards where the clutch would be.  There should be a harness up there that should have a jumper in it to connect the two wires with out the clutch control relay.This would make sense why its not working if I am reading the schematic correctly.  It reads the lack of voltage on that wire as the clutch being pushed and will not turn on.If you want to test this theory you could temporarily put voltage on that green wire at the servo and then see if it allows it to turn on</blockquote>