Reply to thread

Message: <blockquote data-quote="sluggish94" data-source="post: 1471338" data-attributes="member: 25015">Im going to use these Edelbrock short tube headers. [ATTACH=full]6421[/ATTACH][ATTACH=full]6422[/ATTACH] They came with the purchase of the car but I hadn't really given them any attention. The previous owner mentioned that he tried to install them. Obviously he failed cause they're on my table right now. With good reason though, because I checked the mating surface with a straightedge and they're not completely flat. I'll be taking them to a machine shop to get trued. I tried looking up any identifiable numbers online but with no luck. I didn't even know Edelbrock made headers for the 302 Windsor! They have the EGR tube welded on which looks like it was definitely there from the manufacturer, so I'm inclined to believe they are specific for SN-95. I also think these are ceramic coated, considering they are used and don't look like the chrome or steel ones after some heat cycles. You can tell the manufacturers  tried to keep the symmetry between each side really close. I like them and I think they'll do ok for my intended purpose. [ATTACH=full]6423[/ATTACH] Gonna trim this gasket just a smidgeon and hopefully throw them on this weekend.</blockquote>