Reply to thread

Message: <blockquote data-quote="dsg gts" data-source="post: 725717" data-attributes="member: 12862"><p>so today i took it all apart.(the intake) come to find out that the black gasket sealer i put on was done wrong. massive leak. ok so i fixed that problem.put it all back together with everything checked and rechecked. made sure that there were no vac leaks. all tubes if there was a doubt it got replaced. set the timing at 14 degrees. fired it up . well i tried to anyway. it just cranked. so i pulled the dist again. went and did the number 1 plug wire ect. still all it did was pop. just for grins i pulled the mass air flow sensor. it started right up. it idled at 1000 rpm. but very rich. so i plugged in the mas, it made no difference as to how it ran. does that mean that my mas is junk. i pulled it apart and cleaned it i can't see any broken wires nor was it dirty. but i cleaned it anyway. my next question is can i run a stock cobra mas with my combo? all trickflow with 70mm throttle body and 24 lb injectors? or should i just go out and buy the one from lmr. 76mm bbk for 24lb injectors. I'm not sure how big the one i have on it now is. all i know isit is a Graniteli unit. set for 24lb injectors. there is no markings on this unit other than the name. what do you guys think?</p></blockquote><p></p>