Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
TECH
General Tech
Engine braking
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="CC&#039;S95GT" data-source="post: 1255467" data-attributes="member: 10547"><p>Sometimes. I have 4:10 gears so my rpm's run higher. But if I put it in neutral and coasted to a stop the rpm's would hang about 1000-1200 rpm's. Sometimes it would come down slowlyon it's own, sometimes bliping the throttle would bring it down , sometime nothing would.</p><p>I pulled it off and ran a restistance ck on it and found a dead spot near the idle position. You can also ck it installed by back pining the connector.</p><p>If using a digital volt/ohm meter make sure you move the throttle very slowly or you may miss the dead spot. Once you find something repeat the test amd make sure the dead spot is in the same location every time,</p></blockquote><p></p>
[QUOTE="CC'S95GT, post: 1255467, member: 10547"] Sometimes. I have 4:10 gears so my rpm's run higher. But if I put it in neutral and coasted to a stop the rpm's would hang about 1000-1200 rpm's. Sometimes it would come down slowlyon it's own, sometimes bliping the throttle would bring it down , sometime nothing would. I pulled it off and ran a restistance ck on it and found a dead spot near the idle position. You can also ck it installed by back pining the connector. If using a digital volt/ohm meter make sure you move the throttle very slowly or you may miss the dead spot. Once you find something repeat the test amd make sure the dead spot is in the same location every time, [/QUOTE]
Insert quotes…
Verification
Post reply
Random media
Latest posts
What Did You Do To Your Car Today?
Latest: NEW EDG
39 minutes ago
The Garage
cup/drink holder upgrade ideas?..
Latest: Slice
54 minutes ago
Exterior and Interior
A
1995 crank but no start situation
Latest: Armand
56 minutes ago
94-95 5.0 - Specific
V6/GT rear spoiler 94/95?
Latest: Slice
57 minutes ago
Exterior and Interior
Leaky oil temp sending unit
Latest: Daryl
Today at 7:12 PM
94-95 5.0 - Specific
Share this page
Reddit
Pinterest
Tumblr
WhatsApp
Email
Share
Link
Forum statistics
Threads
78,555
Messages
1,536,137
Members
16,201
Latest member
jgib8795
Members online
ju015dd
Forums
TECH
General Tech
Engine braking
Top