Reply to thread

Message: <blockquote data-quote="uncltrvlnmatt" data-source="post: 237277" data-attributes="member: 8290">Tools needed Phillips screw driver, 8mm 1/4 drive socket w/ ratchet and extensions, T-20 torx socket, flat tip screw driver.1) Remove 2 8mm head bolts from bottom plastic trim panel under steering wheel.2) Remove trim piece has 3 push in clips on the top, pry carefully with flat tip screw driver to get these out.3) Remove 2 8mm head bolts from metal support under plastic trim piece and remove support.4) Remove 3 screws from under neath trim peice under steering wheel with phillips screw driver.5) On Bottom trim peice there is a phillips head plastic screw turn approxamately 1/4-1/2 turn and remove lower trim peice.6) Carefully lift top trim peice to gain access to top T-20 torx screw for multi-function switch.*****NOTE***** TOP TRIM PEICE WILL NOT COME OUT DUE TO KEY SWITCH, USE CARE NOT TO BREAK TOP TRIM PEICE.7) Remove 2 T-20 torx screws from multi-function switch.8) Remove switch carefully and disconect the 2 wiring harness plugs, and remove multi-function switch.To reinstall perform directions in reverse.This job took me approxamately 1 hour to do.</blockquote>