Reply to thread

Message: <blockquote data-quote="S351Saleen" data-source="post: 541447" data-attributes="member: 11403">quote author=5.Woahhh link=topic=37031.msg635597#msg635597 date=1240427900]Very nice ridesKind of beat of you calling him out. He has no reason. Its not like Handz who never post pictures of anything. Sorry not everyone is HXC track driver like you.</blockquote>Thanks Buddy! :icon_salut: :icon_salut: :thumbsup: <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite9" alt=":eek:" title="Eek!    :eek:" loading="lazy" data-shortname=":eek:" />ccasion14:I'm not sure if the non carbon fiber heat extractor hoods said Saleen or not, I will find out for you!14K!!! You would have STOLEN it for that!! I here ya on the Griggs, #77 has a full Griggs suspension and it a blast to drive too!!They are around 17" long, and 3 1/2" tips. With the roll the opening on the tip is only 3" but if you measure them they are 3 1/2" across.They get smaller at the end so you can weld them onto a 2 1/2 pipe. Just cut your old tails back and put these on!I had to go to an exhaust shop because the Flowmaster set up was not fitting right at all, the H pipe I bought was pretty bad too. Everything needed to be cut and rewelded. Not sure if this had to do with it being a 351 and Saleen notched the K member and moved the engine back also. On my other one with a Griggs Kmember things seemed to fit alot better than this car. :dontknow:But you will probably have to have a shop adjust the tailpipes to get the right angle for the Saleen valance and weld on the tips.Stock Saleen Borla tips were 3" across at the exit.....these 3 1/2" rolled tips really fill out the rear exhaust openings better I think.[/QUOTE]