Reply to thread

Message: <blockquote data-quote="JDwhite98gt" data-source="post: 855064" data-attributes="member: 10517">I have an 03 PI motor first off. Well a week ago I was changing gaskets and the plastic coolant nipple that comes out of the intake broke, so I modified the intake slightly to get the hose on there and it's still leaking enough to flood the passenger side rear spark plug hole and cause high RPM miss firing. Anyway, I found another PI intake for a really good price but its from 99/2000 so no aluminum crossover...which is ok for me I dont really care at this point. Problem is I need to incorporate the driver's side coolant sensor. I know there are a couple ways of doing this (extend the wires and go into the head...but where? Does anyone have pictures?)(or I use a "T" on the passenger side and the driver's side sensor is long enough to reach, which is my prefered method since I dont feel like soldering in my carport at 8PM tonight). So question is, are there any problems associated with using the "T", does anyone have any info on the correct size fitting I need and are you sure the wires are long enough to reach?</blockquote>