Reply to thread

Message: <blockquote data-quote="g36 monkey" data-source="post: 875982" data-attributes="member: 10997">I am using Harland Sharp 1.73:1 pedestal mount rockers. I am having trouble figuring out zero lash because I'm a noob.I was planning on calling harland sharp at some point next week to get over the phone instruction ha.But what I did was spin the motor until the valve was all the way up (fully seated) then tightened the rocker down, but sort of just snug.Then spun once to get the exhaust side seated and did the same, then cranked over twice to let the line get put in place.And the line is closer to the outside which would make the rods shorter than they need to be I believe, which is strange because I put in a .500 lift cam.</blockquote>