Reply to thread

Message: <blockquote data-quote="justinschmidt1" data-source="post: 981294" data-attributes="member: 8889">]I ordered the new front facing on3 kit with the upgraded 67MM ball bearing turbo.Hoping I dont run in to any big issues but it seems like this new front facing kit is solid and most people can get it together without an issue.  I may end up replacing the wesategate and the v clamps depending on how it goes together but im prepared to deal with it.The motor and fuel system should handle the power but im worried about the transmission.  Its a built 4r70w but I dont know if the drum has been upgraded and its just running the better hardened shaft....JR built it and he told me a while ago that it should be goof for 600 ft lb at the tire but id rather not push it....at least not anytime soon.Im gonna have to see what the torque figures look like cause im kind of worried about that big hit of torque when the turbo first spools.  Im running the edelbrock victor jr manifold, stg 3 ported pi heads, and hp292 cams so it should make a good bit of power on low boost.Hopefully the setup will actually help level out that torque and keep it from spiking too hard since id really like to keep the torque figure around 550 for peace of mind.</blockquote>