Reply to thread

Message: <blockquote data-quote="ttocs" data-source="post: 852220" data-attributes="member: 11896"><p>it is a seperate piece, but the way ford attaches it is through melting the plastic pieces on the back together. I use a hot iron and melted them off of the same piece of my truck while carefully prying out. It would have been nearly impossible to crease that one as it was made from a good plastic, as I would expect this to be made from. Once it is off just a little glue, wrap around the sides and then cut of the extra and it would not even need to be clean since the back would not be seen. Just use a little glue to put it back together, or you can use your hot iron to reconnect the plastic.</p></blockquote><p></p>