Reply to thread

Message: <blockquote data-quote="Venomous96Cobra" data-source="post: 779219" data-attributes="member: 11458">let me clarify! I know exactly what DirtySnowBall302 is refering to! I did a white face conversion on my 90Gt they were NOT overlay's which meant that the needle's and the original faces had to come off! The only problem with that is that these needles are set in place and calibrated! removing them and replacing them sometimes causes the needles to be a bit off!!!So if you have white faces check to see if the are replacement faces or overlays! this may be part of the problem :wink:If they are overlay's move on to getting a temp gauge ( I have an automer phantom mechanical water temp gauge full sweep 0-280 complete w/ attached temp probe $45 shipped sell's for about $90 new...</blockquote>