Reply to thread

Message: <blockquote data-quote="ttocs" data-source="post: 1439931" data-attributes="member: 11896"><p>I think I found one or two aftermarket versions that would work but at the moment I am trying to make the combination I have now work.  I got some 1/4" thick steel and cut it to size and did some minor bending on it so that it was flat against the stock bar and welded it on.  Tomorrow I am going to drill the holes about an inch back to bring the bar forward a little bit.  Its as far as I can move it before the bolt would go through the pipe part of the bar.  Hopefully its enough and if not then I will look at other options.</p></blockquote><p></p>