Reply to thread

Message: <blockquote data-quote="Adam" data-source="post: 8069" data-attributes="member: 8249">All you have to do is cut open the main plastic sheath that holds the drivers side sensor wire(among a billion other wires), pull the wire out(not cut just pull it out ) run it down the drivers side of the engine. There is a block plug there, take that out (all the coolant will drain out) and guess what screws right back into that same hole? Yes..the sensor that was on the drivers side of your old NPI intake. no reason to tap anything. Unless you like metal shavings everywhere.Oh and I picked up 72rwhp and 51rwtq with PI headswap. Also added, VT Stage 1 cams, and FRPP shorties.Adam</blockquote>