How to Get Weld Wheels to fit without spacer
- Thread starter MustangMatt96GT
- Start date
ttocs
Post Whore
why wouldn't you want the pizza cutters as far out as possible? Seems like with the smaller tire contact patch that having them out a little further would help it corner a little better. Now obviously pizza cutters are not made for cornering but if you are on the street with them it seems like it would help?
RAU03MACH
Legend
The offset moving the front tire out
Looks horrible
I seen a set on a car and the middle of the tire was sticking out like low rider
Looked stupid
Looks horrible
I seen a set on a car and the middle of the tire was sticking out like low rider
Looked stupid
RAU03MACH
Legend
These pro stars are a pretty solid rim
And the tire that I have dot approved
The bead is pretty solid just a well put together tire
And the tire that I have dot approved
The bead is pretty solid just a well put together tire
ttocs
Post Whore
oh ok I thought it was a performance thing. How big was the spacer to make it stick out that far?
RAU03MACH
Legend
The ones I seen was 5/16 thin
And that pushed it out
Looks dumb
And that pushed it out
Looks dumb
RAU03MACH
Legend
I did not even like the offset I have
I wanted a bit more to the inside
Right now mine is about flush with fender
I wanted a bit more to the inside
Right now mine is about flush with fender
Mach1Fran
New Member
Because I dont have $ for 17" alumastars, im going to deal with the pizza cutter wheel poke. Does anyone know the part number for moroso or ARP "direct fit" studs for an 03? Dont want to drill anything out...
ttocs
Post Whore
double check me but I think this is what I used on mine. I just used a bearing to set them.
