Reply to thread

Message: <blockquote data-quote="bhorne89" data-source="post: 1113984" data-attributes="member: 9235">Thanks guys, I am hoping to build an extremely nice street car for local cruizes, shows and races!  I just painted the engine bay Sonic Blue to match the car, and tucked the wires to clean up the engine bay!**Question, does anyone have a nice write up on how they ran the AN fuel lines.  I am getting ready to install the fuel system next, and then finish the suspension.  This is the fuel system so far.  I wanted a nice fuel system to support the engine and supercharger, but am not a fan of the an lines showing in the back, and wanted a clean install.  I started with a 2004 Mach 1 gas tank, added a Lethal Performance 2 pump fuel hat.  I installed two Aeromotive stealth 340 lph pumps in it, and bought their adapter wiring harness to wire into the 95's harness.  It came out extremely clean and bolted right in.  This fuel hat is used on 99-04 gt, and Mach 1's to give them a return style fuel system so it was perfect.  It gave me a -10 feed and a -8 return line, I ran the -10 to a black Trick Flow 10 micron filter and to a aeromtive Y-Block, from there to the two aeromotive rails, off the back of them to an Aeromotive regulator and the -8 return to the hat.  The only thing I don't have and am unsure of is the size of injectors to use?  I am trying to figure out where to run the y-block and regulator to look clean.  thanks for any help.</blockquote>