Reply to thread

Message: <blockquote data-quote="heavyhorse1" data-source="post: 1584089" data-attributes="member: 38196">I have a 95 3.8 v6 , I have this as a project , I went to the car 2 weeks ago and when I went to start it it ran for about 5 seconds , then I tried to start it again and won't start. I have 40 psi pump pressure when I turn on the ignition. I have had the ccrm checked out and is ok.when I fit a light to the spark plug, I am getting a spark. When I check the crank shaft position sensor I get 1.6-1.7 volts AC when I crank the engine. When I  fit a noid light to the injector it does not flash, I have voltage to the injector. I have changed the PCM and I still have the same fault. When I plug in the diagnostic meter the only fault I have is engine temperature control sensor.Could it be the ignition control module?When I spray starting fluid in, it will start but not for long.Can anyone help me.</blockquote>