Reply to thread

Message: <blockquote data-quote="ttocs" data-source="post: 1440577" data-attributes="member: 11896">ok so after some time researching in my electrical bible I found these two pages.<img src="https://c2.staticflickr.com/2/1898/42872227250_c531848837_b.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" /><img src="https://c2.staticflickr.com/2/1854/29744365607_a534d3e493_b.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" />following that I found I needed to find the red/yellow wire and the dark green.  I looked through the harness connector diagram and found the wires and connected my light to them.<img src="https://c2.staticflickr.com/2/1879/43773323715_471a4b249c_b.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" />With the key on the light lit up and then stayed on showing that there was an error somewhere.  Is the diagnostic plug under the glove box?  I tried jumping those two wires but I could not get any codes to flash.  Makes me wonder if the abs module is bad or....edit 3 hrs later - Found the diagnostic harness its the by the battery/engine fuse box and of course marked with a big red cap saying something about brake testing.  I grounded the wire I needed to and found no difference, the light just stayed lit up.  I remembered that there were two harnesses that could plug into the abs pump and the smaller one actually had another harness that it could plug into as well.  I was not sure which was right so I just picked one at the time.  Tonight I went back and swapped those two and then the light started blinking to indicate the left front wheel speed sensor was reading faulty.  I have not had a chance to check it out yet but will later tonight.</blockquote>