Reply to thread

Message: <blockquote data-quote="extreme_21" data-source="post: 492073" data-attributes="member: 9565">You could always jump the DLC for the ABS in the engine bay near the fuse box, thus if there's any stored codes the ABS light will flash the fault/faults stored. Jump terminals #2(org/wt) and #6(blk) at ABS DLC. Once DLC is jumped, turn ignition on, ABS light in dash will begin to flash. If there's any fault/faults stored they will be displayed but only once..hehe so don't mess up or you'll have to start all over. If there's no fault stored, ABS will flash code #12 then remain on untill ignition is turned off and jumper wire is removed.Here's some ABS codes I have on-hand:12(system ok)19(ABS Control Module)22(RF Valve)24(LH Valve)26(Rear ABS Valve)31(RF Wheel Sensor)32(RR Wheel Sensor)33(LF Wheel Sensor)34(LR Wheel Sensor)41(RF Wheel Sensor)42(RR Wheel Sensor)43(LF Wheel Sensor)44(LR Wheel Sensor)61(Pump Motor/Motor Relay)63(Voltage Interruption)69(Low Voltage)78(Sensor Frequency)</blockquote>