Back from the dead - Coyote swap

[white95]

Are you using the MT82?

 

[03torchgt]

Did you get the BIM-01-02 for the gauges to work off the obd2 connector?

I haven't but I'll look into it! Thanks for the heads up.

I remember doing that awhile ago too. Nice fit! Is that a slushomatic or pedal assisted shifter dohicky? Curious on your PCM placement. Ah, the memories......

It's a pedal assisted shifter dohicky lol Not sure where it's going yet.

Are you using the MT82?

I am!

 

[5-oh-MUSTANG]

with the gen3 motor, did u have to do any clearancing with the gen3 intake manifold and the cmcv at the back of the intake?

 

[white95]

with the gen3 motor, did u have to do any clearancing with the gen3 intake manifold and the cmcv at the back of the intake?

Typically that stuff gets removed for clearance.

 

[03torchgt]

with the gen3 motor, did u have to do any clearancing with the gen3 intake manifold and the cmcv at the back of the intake?

Honestly I’m not sure I’m not doing the labor myself.

 

[cobrajeff96]

MM has been selling offset motor mounts specifically for those running Gen2+ motors and want to keep the CMCVs attached and active. Some people have been lucky enough to 'persuade' the firewall with a hammer and make it all fit. Others, like me, just delete CMCV by physically locking them out and getting them tuned out of the PCM. And in my case I dremeled its attachment off the manifold runner, then sanded it down, then painted the whole thing. I think those are the only options for anyone, with an Fox/SN95 that is.

 

[cobrajeff96]

Meant to say Gen2+. Gen1 didn't have the bulky vacuum solenoids on the top and back sides of the manifold.

 

[03torchgt]

MM has been selling offset motor mounts specifically for those running Gen2+ motors and want to keep the CMCVs attached and active. Some people have been lucky enough to 'persuade' the firewall with a hammer and make it all fit. Others, like me, just delete CMCV by physically locking them out and getting them tuned out of the PCM. And in my case I dremeled its attachment off the manifold runner, then sanded it down, then painted the whole thing. I think those are the only options for anyone, with an Fox/SN95 that is.

https://lmr.com/item/PT-6504BLK/mustang-coyote-swap-engine-mount-kit-79-04

Are these the offset motor mounts? These are the ones I bought.

 

[cobrajeff96]

No, Maximum Motorsports makes them.