Reply to thread

Message: <blockquote data-quote="JRad405" data-source="post: 993226" data-attributes="member: 14125"><p>Just a little heads up with the MM plates.  I think they have a drill template.  Just check it before you punch holes and drill to make sure the actual plates line up properly.  I guess the template I used from their website wasn't as good at the time and I drilled one hole off.  Long story short I stood with a file for like 30 mins trying to make it like .25 of an inch to fit the plate.  So just line the actual plate up first to check.</p></blockquote><p></p>