Reply to thread

Message: <blockquote data-quote="belber095" data-source="post: 1179713" data-attributes="member: 17353">So when i was bleeding my brakes, everything was going how it should, but then when i went to retighten it after a few releases (don't have a bleeding kit, so i had my dad pump it 3 times with the valve closed and hold it, then i'd open the valve to let the air out, close it, and repeat) and the valve wouldn't shut.  it keeps spinning in either direction.  did i back it out too far? is it salvageable, or do i need to exchange it for a new caliper?this was on the rear driver's side caliper if that matters.</blockquote>