Bottle Heater Wirign Help

[MustangMatt96GT]

I have a question on how i ground at the swtich. It didnt come with a switch, but the one i am using only has two prongs. An in and an out rihgt? I wiried in a light at the bottle before pin 86 inline just to show when the heaters on and not, but it wont go on, and I have a feeling its because there is no ground.

Thanks guys.

 

[SRT Handz]

Make sure wherever the ground is that that its touching bare metal and not paint

 

[MustangMatt96GT]

I got it taken care of. Amazingly enouhg, the bare metal wasnt a good enough ground point. SO i put it to the bolt of the bottle brackets, and amazingly it worked!

 

[vermilion]

matt what is your current setup on that teksid block? ive located one and possibly doing the 4v swap. everything from a mark 8.

 

[MustangMatt96GT]

I dont have a teksid. I want to bulit a high compression 2v with it. I am among for 350 n/a but mainly 12s on motor and 104 octane. And then I want it to handle a twostagr of nitrous. 125 at the tree and then 175 more at the 330 mark or so.