Reply to thread

Message: <blockquote data-quote="blackgt96" data-source="post: 592325" data-attributes="member: 11553">Alright guys I'm not a genius when it comes to cams. i recently bought a set of custom grind comp cams off of a guy on svtp. he said they are for a NPI N/A 96-98 2v. i know i'll need to buy valve springs for the install but is there anything else i need? would the comp cams beehive valve springs be good for these? here is most of the info off of the spec cards. please tell me anything i may not know about these. also, i already have PI cams in my car now and i'm pulling out the motor to put a new engine in. would i be better off putting the PI cams in or these? thanks!!part #: 102-000-9L / 102-000-9R              INTAKE  EXHAUSTvalve adjustment   hyd      hydgross valve lift:   .500     .500Duration @.006 tappet lift    267      277valve timing OPEN     CLOSE@ .050   INT: 0   BTDC: 50  ABDC       EXH: 55    BBDC: 5   ATDCTHESE SPECS ARE FOR CAM INSTALLED @ 115.0 INTAKE CENTER LINE               INTAKE    EXHAUSTduration @ .050      230       240lobe lift           .2740     .2740lobe separation      115.0</blockquote>